Cablu Audioquest Rocket 33 de 1,8 m pentru boxa centru (UN SINGUR CABLU), original 100%, cumparat din SUA.
Nou, nefolosit, fara nicio urma de uzura.
Predare personala in zona Bucuresti, cu proba la cumparator.
Trimit in tara cu curier rapid, in ambalaj adecvat. Plata produsului + transport prin ramburs la curier.
Numai vanzare, fara schimburi va rog.
Pret de lista: 290 USD.

SPECIFICATII
- Conductor solid din cupru pur de 2,0 mmp (14AWG);
- Geometrie Double Star Quad: fiecare polaritate (+ si -) are cate 2 conductori, astfel ca poate fi transformat usor in cablu bi-wire sau bi-amp;
- Izolatie din spuma de polietilena;
- Ecranare cu straturi pe baza de carbon;
- Conectori banana (2+2) placati cu aur;
- Sudura la rece intre conductori si conectori.

Descrierea producatorului:

SOLID LONG-GRAIN COPPER/PERFECT-SURFACE COPPER (LGC/PSC) CONDUCTORS
Rocket 33 uses a carefully finessed combination of Long-Grain Copper (LGC) and extremely high purity Perfect-Surface Copper (PSC) conductors. All conductors are solid, which prevents strand interaction, a major source of distortion. Surface quality is critical, because a conductor can be considered as a rail-guide for both the electric fields within a conductor and for the magnetic fields outside the conductor. LGC has fewer oxides within the conducting material, less impurities, less grain boundaries, and definitively better performance. The astonishingly smooth and pure PSC further eliminates harshness and greatly increases clarity compared to OFHC, OCC, 8N and other coppers.

FOAM POLYETHYLENE (FPE) INSULATION
Any solid material adjacent to a conductor is actually part of an imperfect circuit. Wire insulation, circuit board materials all absorb energy (loss). Some of this energy is stored and then released as distortion. All of Rocket 33 conductors use air filled FPE (Foam Polyethylene) insulation because air absorbs next to no energy, and Polyethylene is low-loss and has a benign distortion profile. Thanks to all the air in FPE, it causes much less of the out-of-focus effect common to other materials.

CARBON-BASED NOISE-DISSIPATION SYSTEM (NDS)
It's easy to accomplish 100% shield coverage. Preventing captured Radio Frequency Interference (RFI) from modulating the equipment's ground reference requires AQ's Noise-Dissipation System (NDS). Traditional shield systems typically absorb and then drain noise/RF energy to component ground, modulating and distorting the critical "reference" ground plane, which in turn causes a distortion of the signal. NDS's layers of carbon-loaded synthetics "shield the shield," absorbing and reflecting most of this noise/RF energy before it reaches the layer attached to ground.

DOUBLE STAR-QUAD GEOMETRY
The relationship between conductors defines a cable’s most basic electrical values (capacitance and inductance). However, even when those variables are kept in a reasonable balance, the relationship between conductors can be varied in ways that greatly affect the sound. The Double Star-Quad construction of Rocket 33 allows for significantly better dynamic contrast and information intelligibility than if the same conductors were run in parallel.

COLD-WELD SYSTEM
This novel plug design enables a perfect heat-free connection between cable and plug. The connection between the plug and conductors is made using AQ’s Cold-Weld System, which provides a superior connection that ensures that the structural integrity of the conductor is kept completely intact. Cold-Welding avoids the introduction of heat and extra materials like solder, which change the character of the wire at the point of termination. The Cold-Weld System refers to a combination of high pressure at the point of contact and the use of copper- or silver-impregnated paste.